When replacing the rear wheel bearing, the spacers, against which the bearings are tightened, should be checked for defects.
If they are worn, this is too often due to incorrect assembly, the most common mistake being tightening the rear axle nut to the wrong torque.
Fitting a worn spacer results in play, which not only damages the bearing, but can also cause irreparable damage to the bearings.
This set contains not only the spacers on which the snap rings rotate, but also the center spacers that hold the bearings apart. The set is intended for both left and right sides, or a complete set that allows you to replace everything at once.
Useful information from Paruzzi magazine and from our YouTube channel :
Look for more technical articles on the page Paruzzi Magazine